Pool Management Tips Part – II

Remove All Winterizing Plugs and Replace Them With the Correct Drain Plugs

If you live in an area where the temperature stays below freezing for much of the winter, then you most likely replaced most of the drain plugs in your equipment with special winterizing plugs. These winterizing plugs provide a very tight seal and prevent any damage due to leaks or ice during winter. After reconnecting your equipment, you will want to replace the winter plugs with the normal, correct plugs to allow the equipment to run properly.

Shock The Pool to Remove Bacteria and Contaminants

Shocking your pool is the last and final step for getting rid of all the dirt, debris, bacteria, algae spores, and other organic contaminants that may have entered your pool during the winter offseason. After shocking the pool, run the circulation system for at least 2 hours before adding an algaecide.

Prevent Algae All Season Long

For a clean and algae-free swimming season, it is recommended to start treatment before the first swimmers even jump into the pool. Both of these products, when used both at the beginning of summer and regularly during the season, will prevent the growth of most types of algae, and help keep your pool clean, clear, and fresh all year long.

Brush and Vacuum Your Pool Thoroughly

Even if you use a solid cover on your pool during the winter, there will still be a fair amount of dirt and debris in your pool. It is a good idea to give your pool a thorough brushing and vacuuming before shocking the pool. This will prevent any algae or bacteria from clinging to the pool walls, and help your filtration and sanitation systems start to eliminate any algae spores.

When brushing your pool, it is a good idea to start in the shallow end of the pool and move towards the deep end. If you can, vacuum your pool directly to waste. Once you have brushed and vacuumed your pool, allow your circulation and filtration systems to run overnight before shocking the pool.

When Balancing Water, Start With Total Alkalinity

Once you have tested your water chemistry, it is time to start adding chemicals to balance your water. It is important to begin with balancing your Total Alkalinity because this will help to bring your other chemicals closer to their normal range, making it significantly easier to achieve a safe and clean pool.

To lower the Total Alkalinity, you can use either Leslie’s Dry Acid. This product will quickly decrease Total Alkalinity levels in your pool. Just 1 ½ pounds of Leslie’s Dry Acid will lower the Total Alkalinity by 10 ppm in 10,000 gallons of water. To raise Total Alkalinity by 10 ppm in 10,000 gallons, use 1 ½ pounds of Leslie’s Alkalinity Up.

Once the Total Alkalinity has been brought to within 80 and 120 ppm, you can begin to adjust the other chemicals. To increase pH, adding Leslie’s Soda Ash will help raise it to an acceptable range. To decrease pH, you can again use Leslie’s Dry Acid.

If the Calcium Hardness is too low, just 1 ¼ pounds of Leslie’s Hardness Plus will raise the Calcium Hardness by 10 ppm in 10,000 gallons of water. It is much more difficult to lower the Calcium Hardness than to raise it, so be sure not to let the calcium levels get beyond 400 ppm.

For more details on our products and services, please feel free to visit us at Pool Management jobs, Aquatic Management companies & Swimming Pool staffing


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s